Elxis CMS Forum

Extensions => Components => Topic started by: rotor on July 17, 2007, 22:40:37

Title: Pm for Elxis??
Post by: rotor on July 17, 2007, 22:40:37

Can anyone recommend a  Private Message component to use with elxis?

I did think that I'd seen a commercial pm system somewhere here but cant seem to find it now ....


Geoff

Title: Re: Pm for Elxis??
Post by: datahell on July 18, 2007, 00:48:08

There is the PMSGS commercial plugin but it is for Elxis's PowerBoard forum.

Title: Re: Pm for Elxis??
Post by: rotor on July 18, 2007, 10:48:28

Yes that was the one, just couldn't remember which it was

thanks datahell - does it announce messages in the front end or do you have to go into the forum to get notification?

Geoff

Title: Re: Pm for Elxis??
Post by: datahell on July 18, 2007, 12:52:37

It works only inside the forum. BUT you/we could create a small module that will indicate new messages. Module could use ajax to display you the message without visiting powerboard... Contact GO UP Inc if you are interesting. I repeat that you will have to install the powerboard component (it is free/open source) and to buy the PMSGS plugin for it (12 euro - www.goup.gr/shop ). You won't pay the additional module, I will create it for free for you.

Title: Re: Pm for Elxis??
Post by: rotor on July 18, 2007, 16:42:41

Ok,

I've sent 12 euros via paypal .... your e-store merchant still won't accept my address here in Australia so I've sent it to the same email address as when I purchased e-dir (along with the invoice number)

Thanks for the offer of the mod for the front end - much appreciated


Geoff

Title: Re: Pm for Elxis??
Post by: datahell on July 18, 2007, 19:28:38

Module is ready, I am sending it to you right now via e-mail.

Contact  ia [AT] goup [DOT] gr if you face problems getting the PMSGS plugin from our shop.

Thank you.

Title: Re: Pm for Elxis??
Post by: rotor on July 19, 2007, 01:00:42

Hi,

ok thanks for everything - all works fine.

Had installed SMF but decided to use powerboard as it's improved out of sight since it's predecessors mamboboard and simpleboard .....  just needs a little work on it looks  :(


Question on Powerboard - Is the latest version 1.0 ...


Geoff